ABB RMC-100 - Page 3

2105552MNAE | RMC-100 | 3
3.4 Unpack and inspect................................................................................................ 31
3.5 Basic hardware installation ...................................................................................... 31
3.5.1 Ground the controller ................................................................................ 31
3.5.2 Standalone mounting ................................................................................ 32
3.5.3 Mounting when using an enclosure .............................................................. 32
3.5.4 Wire serial communication ports .................................................................. 33
3.5.5 Wire input and output................................................................................ 35
3.6 Connect expansion modules .................................................................................... 37
3.6.1 Connect additional devices with Ethernet ...................................................... 37
3.6.2 Connect TFIO modules............................................................................... 39
3.6.3 Connect third-party serial modules .............................................................. 41
3.7 Power the RMC ..................................................................................................... 41
3.7.1 Power-on sequence ................................................................................... 41
3.7.2 Power with battery and charger................................................................... 42
3.7.3 Power with external power source ............................................................... 44
3.8 Enable lithium battery backup ................................................................................. 45
4 Startup ....................................................................................................................... 46
4.1 Configure the RMC using PCCU32 ............................................................................. 46
4.1.1 Install the PCCU32 interface ....................................................................... 46
4.2 Establish local communication ................................................................................. 46
4.2.1 Using the USB port ................................................................................... 46
4.2.2 Using the Ethernet ports ............................................................................ 48
4.2.3 Using the MMI port (when using enclosures) ................................................. 52
4.3 Configure basic parameters ..................................................................................... 52
4.3.1 Configure the station ................................................................................. 52
4.3.2 Change the LCD display ............................................................................. 53
4.4 Configure serial communications .............................................................................. 53
4.4.1 Configure serial communication ports ........................................................... 53
4.4.2 Enable serial port switched output power ...................................................... 56
4.5 Configure Ethernet network communication ............................................................... 56
4.5.1 Network modes ........................................................................................ 57
4.5.2 IP addressing ........................................................................................... 57
4.6 Configure the RMC for 1 Network mode (2-port switch)................................................ 58
4.6.1 Remote access to RMC by host (connections) ................................................ 58
4.6.2 Local access to RMC by host (connections) .................................................... 59
4.6.3 Daisy-chain connection support for other devices ........................................... 60
4.6.4 Procedure to configure 1 Network mode ....................................................... 61
4.7 Configure the RMC for 2 Network mode ..................................................................... 62
4.7.1 Remote access to RMC by host (logical diagram) ............................................ 63
4.7.2 Local access to RMC/daisy chained devices (logical diagram) ............................ 63
4.7.3 Procedure to configure 2-Networks mode ...................................................... 64
4.8 Expand serial communication capacity ...................................................................... 67
4.8.1 Expand with ABB’s XIO .............................................................................. 67
4.8.2 Expand with third-party Ethernet-serial devices ............................................. 67