ABB RMC-100 - Standalone Mounting; Mounting When Using an Enclosure

32 | RMC-100| 2105552MNAE
3.5.2 Standalone mounting
To mount the RMC:
1. Position the RMC on the DIN rail.
2. Push the RMC onto the DIN rail until it snaps into place (Figure 3-1
).
Figure 3-1: Mount the RMC
IMPORTANT NOTE:
To remove the RMC, insert a slotted screwdriver into the access slot of the
DIN rail and release the clip to loosen. See section
8.8.3 Remove the RMC from the DIN rail.
3.5.3 Mounting when using an enclosure
The Xcore enclosure has tags for wall-mounting (Figure 3-2). Mount the enclosure per field
specifications. The RMC is usually already mounted on an internal DIN rail inside the enclosure. To use
non-ABB enclosures, follow the vendor’s mounting instructions.
Figure 3-2: Xcore enclosure top mounting tags and interior view
Legend for Figure 3-2: Xcore enclosure top mounting tags and interior view
ID
Name
1
Tag
2
RMC installed
3
DIN Rail
COMM EXPANSION
USB TYPE B
1