188 | RMC-100| 2105552MNAE
Figure 8-28: Locate and download latest PCCU version from the PCCU product page
8.5 System restart
The RMC has several options for restart. This section provides an overview of those options and the
corresponding procedures for manually triggered restarts.
– Loss of data. Some of the restart procedures in this section cause customer
data, device configuration or calibration data loss. Backup data and co
nfiguration is in
8.1 Preserve data and configuration.
8.5.1 Restart type overview
There are several ways to restart an RMC. Restarts can be manually triggered, or performed
automatically after software updates, power removal, or other system events. Perform manually
triggered restarts onboard or from the user interface (PCCU).
Table 8-3
describes device restarts. Review the implications of each restart type carefully to select the
appropriate method. There might be several methods for the same type of restart.
E: While there are several methods for the warm and cold restarts, ABB
recommends restarts from PCCU32 (Entry mode or device loader).
To Next Page
Loading...
