ABB RMC-100 - Page 5

2105552MNAE | RMC-100 | 5
7.1.2 Analog input calibration (voltage mode)...................................................... 128
7.1.3 Analog input calibration (current mode) ...................................................... 137
7.1.4 Verify analog input calibration ................................................................... 149
7.1.5 Repeat calibration in case of errors ............................................................ 151
7.2 Analog output calibration ...................................................................................... 153
7.2.1 Connect the calibration equipment ............................................................. 153
7.2.2 Analog output calibration with no load ........................................................ 154
7.2.3 Define engineering unit range ................................................................... 163
7.2.4 Drive the AO from a register ..................................................................... 168
8 Service and maintenance .......................................................................................... 168
8.1 Preserve data and configuration ............................................................................. 169
8.1.1 Collect data ........................................................................................... 169
8.1.2 Save the device configuration ................................................................... 172
8.2 Restore the device configuration ............................................................................ 178
8.3 Use the configuration from another RMC ................................................................. 179
8.4 Update device software ........................................................................................ 180
8.4.1 When to upgrade .................................................................................... 180
8.4.2 Software update packages for the RMC....................................................... 181
8.4.3 Download software from the ABB website ................................................... 181
8.4.4 Determine device software part number/version .......................................... 183
8.4.5 Load the update software package ............................................................. 185
8.5 System restart .................................................................................................... 188
8.5.1 Restart type overview.............................................................................. 188
8.5.2 Warm restart with the RESET button .......................................................... 189
8.5.3 Warm restart from the device loader .......................................................... 190
8.5.4 Warm restart from PCCU Entry mode ......................................................... 191
8.5.5 Warm restart from terminal mode ............................................................. 191
8.5.6 Cold restart from the device loader ............................................................ 192
8.5.7 Cold restart from terminal mode ............................................................... 193
8.5.8 Restart using factory configuration ............................................................ 194
8.6 Change the clock ................................................................................................. 195
8.7 Remove and restore power ................................................................................... 196
8.7.1 Remove power from the controller ............................................................. 196
8.7.2 Reconnect power to the controller ............................................................. 196
8.8 Part replacement ................................................................................................. 197
8.8.1 Replacement and spare parts list ............................................................... 197
8.8.2 Return parts for repair ............................................................................. 197
8.8.3 Remove the RMC from the DIN rail ............................................................ 197
8.8.4 Remove the housing cover from the base ................................................... 198
8.8.5 Replace the lithium battery....................................................................... 199
8.8.6 Replace the 12 Vdc battery....................................................................... 199
8.8.7 Replace the electronic board ..................................................................... 200
8.8.8 Replace the LCD assembly ....................................................................... 201
8.9 Maintain cleanliness of the RMC ............................................................................. 201