ABB SCK - Page 74

74 System Manual SCK Gas Sampling System 42/23-81 EN Rev. 4
Danger Where / in what situa-
tion does the danger
arise?
Preventive action
Danger due to harm-
ful gases, jet flames
Due to gases escaping
from the duct opening of
the rotary kiln
 Only enter the danger area
around the retractor when
the shutter is closed.
 Lock the shutter before
commencing work.
 Ensure adequate ventila-
tion of the work place.
 If work is unavoidable in the
area of the duct opening,
wear respiratory protection
in addition to the general
protective equipment.
Risk of scalding due
to hot cooling water
When working on the
cooling water system,
particularly:
 ventilation openings
 Screw connections
 Do not perform work on the
cooling water system until it
has cooled down.
Danger due to harm-
ful anti-freeze
In the cooling water of
the cooling system
 Avoid contact with the
cooling water and the anti-
freeze.
 Wash any cooling water or
anti-freeze off the skin im-
mediately with water and
soap.
 If cooling water or anti-
freeze gets in the eyes de-
spite protective glasses,
rinse them thoroughly un-
der running water, holding
the eyelids open.
 Observe instructions in the
anti-freeze manufacturer's
safety data sheet.
Danger due to harm-
ful lubricating oil
In the pneumatic box, on
the pneumatic motor
filter muffler, inside the
pneumatic motor.
 Avoid contact with lubricat-
ing oil.
 Wash any lubricating oil off
the skin immediately with
water and soap.
 If any lubricating oil gets in
the eyes despite protective
glasses, rinse them thor-
oughly under running water,
holding the eyelids open.
 Observe instructions in the
lubricating oil manufactur-
er's safety data sheet.
Risk of slipping
Around the gas sampling
system due to cooling
water or lubricating oil
that escapes or is
spilled.
 Always keep the floor
around the gas sampling
system clean and dry.