49SCU200 INSITE ENERGY MANAGEMENT SYSTEM
6.4.2.Automations
This page allows to set automatic actions on selected devices if a specific configured event occurs.
It is possible to add up to two conditions per single automation. Available logical operators for multiple
conditions are “AND”, “OR”.
Email notification configuration can be set to following values: - Dedicated: the email is sent immediately
after each automation occurrence.
When adding or editing an automation, please set the following:
Name Set the name of the automation
Time delay
Define for how long the event criteria should be fulfilled in order to consider
the occurrence as an event
Send event If enabled, then event will be shown in events log.
Alarm
Only when Send event is enabled - If enabled, then event will be shown in
alarms log.
Email
notification
If the box is selected, an email will be sent when an event occurs. The email
address has to be defined in “System setup – Communication - Email”.
Status
Status of configured automation, if disabled then automation is not active
and won’t be performed.
To Next Page
Loading...
