ABB TPS48-H33 - Expected Replacement Intervals; Table 10 Expected Replacement Intervals [H]

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
5
Operation and service
Page 34 /
99
© Copyright 2016 ABB. All rights reserved.
HZTL4037_EN
Revision A
August 2016
5.3 Expected replacement intervals
Rotating components
The recommended replacement intervals for compressor and turbine wheels are specified
based on the safety concept for rotating parts (SIKO) and dependent on the operating condi-
tions. These intervals are shown on the rating plate of the turbocharger.
Non-rotating components
Depending on the system-specific operating conditions, a differentiation must be made be-
tween the intervals to be expected for:
 replacing the bearing parts and
 replacing the non-rotating components exposed to hot gas.
A decisive role is played by various influencing parameters which, in extreme cases, can dras-
tically shorten the replacement interval of these parts.
During the prescribed periodic service work, the individual parts are examined for wear and
replaced if necessary.
Component
GAS / MDO
Turbine casing 25000 … 50000
Nozzle ring 25000 … 50000
Heat sheet metal 25000 … 50000
Rotating components See rating plate data
Bearing parts 12000 … 24000
Other casings 50000
Table 10: Expected replacement intervals [h]
GAS = Gas
MDO = Marine Diesel Oil
The specified values are guideline values and not guaranteed values, see Influencing parameters.