Abus HDCC90000 - Warning; User

Configuration
33
 Confirm the settings by clicking on Apply and exit the
menu by clicking on Back.
Warning
Set the response of the recorder for warning messages
and system events here. To do this, activate the "Enable
Event Hint" setting.
You can trigger a warning for the following error types:
 HDD Full
 HDD Error
 Network Disconnected
 IP Conflicted
 Illegal Login
 Exception Error
Parameter
Notifications
Audible Warning
The device emits a repeated
signal tone.
Notify Surveillance
Center
A notification is sent to the
CMS software event log.
Send Email
An email is sent to a
specified email address.
Trigger Alarm Output
The selected alarm output is
switched in the event of a
fault.
User
Warning
Note down the admin password.
The preset password is:
"1 2 3 4 5".
In user management, you can add new users, delete
users, and amend existing settings.
1.
To add a new user, select Add.
Parameter
Setting
User Name
Unique identification
Password
Access code for the device, for the
purpose of device management.
Note: change your passwords
regularly, using a combination of
letters and numbers etc. and note
them down to be stored in a safe
place.
Confirm
Enter the access code again for
security.
Level
IMPORTANT:
More rights can be set on the
Operator level than on the Guest
level.
User's MAC
Address
MAC address of the network adapter
of the PC used by the corresponding
user.
Note:
This limits access to the PC, for which
the MAC address has been entered
here.
2.
Enter the name and password and confirm the
password in the field below.
3.
Select the level and enter the MAC address.
1. Confirm the settings by clicking on OK.
Warning
Follow the instructions below on assigning access
rights.
Setting permissions