Abus HDCC90000 - Fault Rectification; Cleaning and Care of the Device; Note

Fault rectification
59
Fault rectification
Before contacting the Service department, read the following information to determine the possible cause of any fault.
Fault
Cause
Solution:
No power
Power cable not connected
Connect the power cable properly to the
socket
Power switch at OFF
Set power switch to ON
No power supplied from socket
If necessary, use another device at the
socket
No picture
The screen is not set to receive
Set correct video input mode, until an image
is received from the recorder
Video cable is not connected properly
Connect the video cable properly
The connected monitor is switched off
Switch on monitor
No sound
Audio cable is not connected properly
Connect the audio cable properly
Devices connected via audio cable are not
switched on
Devices connected via the audio cable are
not switched on
Audio connecting cable is damaged
Replace cable
Hard disk drive not functioning
Connection cable is not connected properly
Connect the cable properly
Hard disk drive faulty or incompatible with the
system
Replace the hard disk drive with a
recommended hard disk drive
USB connection not functioning
Device is not supported
Connect correct USB medium, USB 2.0
USB Hub was used
Connect USB medium directly
Network access not possible.
Network cable connection loose
Insert network cable.
Network settings (DCHP, IP address etc.)
incorrect
Check and if necessary correct network
configuration, see page 27.
Recording is not possible
No HDD, or HDD not initialised
Install and initialise hard disk drive
Sudden switch-off
The internal temperature of the device is too
high
Clean the device and/or remove any objects
impeding the ventilation
Cleaning and care of the device
Note
 The device is maintenance free.
 Protect the device against dust, dirt and damp.