Abus HDCC90000 - Video Loss

Camera
39
Video Loss
Select the camera channel to be processed under
"Camera".
Tick the Enable "Video Loss" Alarm box and define any
other parameters under "Settings" as required.
The Video Loss alarm is activated when there is
complete camera failure.
Arming Schedule
Select the Arming Schedule tab.
Here you set the times at which the reactions set in the
Linkage Action tab are triggered.
1. Select the day and enter the schedule.
Note
Up to eight time slots, between 00:00 and 00:00,
can be defined in each case, but the individual
time slots must not overlap.
2. Under Copy, select whether or not the setting should
be applied to every day of the week and the holiday
settings.
3. Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
Linkage Action
Select the Linkage Action tab.
Here you can configure the response of the recorder
during an event (e.g. motion detected) by ticking the
corresponding box.
Parameter
Notifications
Full Screen Monitoring
The camera is displayed in
full screen in live view.
Audible Warning
The device emits a
repeated signal tone.
Notify Surveillance
Center
The CMS sends out a
warning message.
Send Email
An email is sent to a
specified email address.
Trigger Alarm Output
The alarm output is
triggered in the event of an
alarm.
Confirm the settings by clicking on Apply and exit the
menu by clicking on OK.