Abus SECVEST - Panel Restart Procedure

31
|
30
10. User menu
During an alarm
⋅ Voice dialler Following an “individual message” and “Message x”, the zone rst triggered
will be announced in addition.
⋅ Alarm panel The zone rst triggered will be announced with each sub-area. Thesub-area
with the lowest number will be rst.
Example:
Alarms were triggered in the following zones in the following order:
Zone 226 Sub-area 3
Zone 225 Sub-area 1
Zone 203 Sub-area 1
The following can be heard over the system:
“The sub-area is deactivated! Attention! An alarm was triggered!
<Zone 225 voice message>, <Zone 226 voice message> Reset required“
Restart Panel
You can use this to restart the alarm panel manually.
This is helpful for some problems, to reset the alarm panel to a dened initial state. All the settings and
congurations are retained.
Note: This menu item is only visible to the administrator, i.e. the administrator must be logged into the
system.
A restart is only possible when
• all partitions are "disarmed" and
• the alarm panel has completed all important communications, transmissions and actions.
Select "Restart alarm panel" by pressing the "Change" menu key.
You are prompted for conrmation.
Press the "Yes" menu key.
At this point you can still cancel the restart.
Press "Back".
There are more details in Section 16.1, Manual restart (switching o and switching back on).
Keypad tones
When “On” is selected, a clicking sound via the loudspeaker is generated by pressing or touching each key.