Safety information
10.7 Test
Only visible to the administrator.
The test menu provides the option of testing the various functions of your system to ensure they are working
properly. Depending on the setup level of your alarm panel, certain functions may not be available.
Select "Test" to access the following menu:
The following options are available:
• Walk test
• Sirens & Sounders
• Door locks
• Outputs
• Prox Tag
• Remote controls
• Emergency buttons
• Telephone call
10.7.1 Walk test
1
. You can test your detectors in the "walk test”. For example, if you want to know
whether a certain detector is functioning properly, you do not have to trigger an
alarm.Simply select "Walk test" and test your detector.We recommend proceeding
as follows:Open the walk test and activate the "Bell – on" menu.
2. A feedback tone sounds in this case when you trigger a detector during the
walk test.
3.
Select "System" and your detectors should be listed (the number of detectors varies
depending on the setup level of the system – in this example you see 4).
4. Then open the window with the rst detector (such as a magnetic contact).
For a motion detector you should move around brie y within its detection
range. Repeat this for all detectors (you may have to do di erent things to
trigger them depending on the type of detector). A er a successful test the
menu should look like the example shown on the le . In this case "A" stands
for a "virtual alarm" that was triggered. The detector is working properly.
Ifthere is no entry "A" for a detector and you have tested all detectors, repeat
the test for the detector in question again. If the entry fails again, contact
your specialist installation contractor.
10. User menu
To Next Page
Loading...
