EVO 150 Controller
26
2 7 1
The system will power-up in Manual mode. All inputs are momentary.
2 7 2
The system will power-up in Servo-Center mode. All inputs are
momentary.
2 7 3
The system will power-up in Automatic mode. All inputs are momentary.
2 7 4
The system will power-up in Manual mode. All inputs are maintained.
2 7 5
The system will power-up in Manual mode and Edge A (Input A) will be
selected. All inputs are momentary.
2 7 6
The system will power-up in Manual mode and Edge B (Input B) will be
selected. All inputs are momentary.
2 7 7
The system will power-up in Manual mode and Line (Input C) will be
selected. All inputs are momentary.
2 7 8
The system will power-up in Manual mode and Edge A and Edge B will
be selected (Centerline mode). All inputs are momentary.
Note: This parameter also affects the operation of the PLC I/O inputs (see page 47).
Fusion Mode Enable
2 8 0
Fusion Mode is disabled. This is the default setting.
2 8 1
Fusion Mode is enabled. For more information about Fusion Mode refe
to page
System ID
2 9 x x x x x
This parameter displays the system ID number.
Parameter 30 is reserved for future use.
Refer to page 44 for a description of parameters 31, 32, 33, and 34.
To Next Page
Loading...
