EVO 150 Controller
6
2. EVO 150
Controller Assembly
• Single-board design
• Optional din rail mounting
• Auto-recovery after power interruption
• Non-volatile memory for user-settable parameters and operating modes
• On-board Ethernet programming port
• Two edge detector inputs for centerline guiding
• PWM motor drive:
Brushed and brushless motors
20 kHz switching frequency
120 watts continuous output power, 24 volts at 5 amps
15 amp peak current limit
Thermistor-based over-temperature protection
• Actuator end-of-travel inputs:
Potentiometer input for electronically-adjustable limits
Limit switch inputs for fixed limits
• Inhibit input
• Input voltage: 24 DC
3. EVO 150
Enclosure
• Low profile
• Environmentally-sealed function switches
• External mounting feet
4. AccuWeb Linear Actuator
• Available with brush DC and brushless motors up to 150 watts.
• Available with standard stroke lengths up to ± 6” [± 152mm] (other lengths available upon
request)
• Available with limit switches or potentiometer for sensing end-of-travel limits and servo-
center position
5. Remote Station (optional)
• Rugged, ultra-compact housing
• Remote guide point adjustment or remote access to digital line guide’s front panel
• Environmentally-sealed function switches and display
To Next Page
