3-40 Machine Maintenance Procedures
eDP and Camera Cable Removal 0
Prerequisite:
LCD Hinges Removal
1. Disconnect the camera cable (D) from the camera module (B) (Figure 3-47).
2. Peel back the tape (C) securing the microphone cable to the microphone board, and
disconnect the microphone cable (D) from the microphone board (A) (Figure 3-47).
Use care not to damage the cable.
Figure 3-47. eDP and Camera Cable Removal
3. Remove the eDP and camera cable from the cable guides and remove it from the LCD
cover (Figure 3-48).
Figure 3-48. eDP and Camera Cable Removal