WORKING WITH THE CONTROL UNIT 5-11
SB1391 Hardware and Setup Guide - Document revision no. 1.14
5.2.4. Adding an Amplifier to the Adjuster Database
ACS Adjuster maintains two databases, one for amplifiers and one for motors. Adjuster accesses
the databases during the adjustment process (for the Amplifier parameters and Motor/feedback
parameters steps, which are described later).
The database comes with some third-party amplifiers already defined. If the system's
amplifier is not in the database yet, it should be added now.
Action Effect of action
1. On the Database menu, point to
Amplifiers, and then click Add
item, as shown in FIGURE 5-7.
The first time that the amplifier database is accessed,
the message in FIGURE 5-8 appears, to prevent the
default amplifier database from being overwritten.
FIGURE 5-7 Add amplifier command
To Next Page
Loading...
Need help?
General