CHANGINGNAMEOF
GROUP 5
===> GROUP 5 <===
Press ENTER on the type of item that is to be named .
(Say GROUPS) Tab through until you get the exact item
(SAY GROUP 5) and then use the scroll up and down keys
to change each letter to input or modify the name of each
Group or other item.
Pressing "DELETE" on an existing letter clears it back to a
space.
Note that the memory of the system is somewhat distributed.
The names of each Zone is kept in the Relay board (GR
2404,2408 or 2416) but the name of the panel is kept in the
clock m emory. Thus if the board is disconnected you will be
able to see the panel name but not the relay names.
Going back to the System Setup Menu the next item is the
WHAT and WHEN MENU. This menu answers the above
question. What controls this relay? When is the next sched-
uled event? etc.
WHAT and WHEN MENU
WHAT CONTROLS GROUPS
WHAT CONTROLS RELAYS
RELAY PROPERTIES
SCHEDULED EVENTS
Scheduled events lists the times in order of occurrence
from all the schedules. This is a good side check on sched-
ule programming to make sure that all the events that
should be happening are in fact happening. Schedules only
operate on a Group so the listing shows when Groups are
turned ON or OFF.
ORDEROF EVENTS
NEXT
SAT: G1 ON 8.00am
SAT: G5 ON 9.00am
SAT: G2 ON 6.00pm
SAT: G5 OFF 9.00pm
SAT: G1 OFF 10.00pm
The events are listed in order from midnight of the day of
the request and extend for a full week. The next event is
indicated by an arrow on the f irst page. Items before the
arrow occurred before the current time.
Page 37
To Next Page
Loading...
Need help?
General