Table 1.3
BTN Beep
This field determines when the switch’s buttons will cause a beeping sound.
Possible Values Result
OFF There will never be a beeping sound when a button is
pressed. Note that any beep alerts set to take place using
the “7 On = _____” or “8 On = _____” fields will still be
executed. Setting “BTN Beep” to OFF only effects normal
button presses, not special alerts.
PUSH only The buttons on the switch will beep when pressed. (Note
that operating the same load(s) from another location will
not cause the beep) There will be no rapid series of beeps
when a disabled button is pressed, it will simply cause the
standard single beep.
Disable Buttons will not normally beep when pressed; however, if
the user presses a disabled button, the switch will give a
rapid series of beeps to alert them that the button will not
operate as expected because it has been disabled.
Push + Disa. Buttons on the switch will give a standard single beep
when pressed. If the user presses a button that has been
disabled, the switch will alert them with a rapid series of
beeps.
Table 1.4
Button 1 Address
This field determines whether Button 1 on the switch will act as the Address
Button (meaning that the user can set and read the address by pushing Button 1
instead of having to press the Address Button on the back of the switch). This
is generally set to “Y” (Yes) except on Digilinks, which are always set to “N”.
Possible Values Result
Y Yes, Button 1 will function as the Address Button
N No, Button 1 will not function as the Address Button
- 6 -
To Next Page
Loading...
Need help?
General