RLY
25
RLY
26
RLY
27
RLY
28
RLY
29
RLY
30
RLY
31
RLY
32
RLY
33
RLY
34
RLY
35
RLY
36
RLY
37
RLY
38
RLY
39
RLY
40
Note that a GR 2432 card in the "Discreet" mode has 4
addresses associated with it. Only the first address on the
card has a delay associated with it. Once this delay is set all
the relays on the board have the same delay time between
operations.
A delay of 1 is the f actory default. This means that in a cabi-
net with 48 relays all being turned on at the same time it will
take just over 3/4 of a second to switch all the relays.
Specifying Normally Closed Relays
In this same RELAY PARAMETERS MENU highlight the
board that needs to be changed and press ENTER. This
takes you to the BOARD SETTINGS MENU.
BOARD 1 SETTINGS
12345678
Normally Closed
-- -- -- -- -- -- --
No Blink
-- -- -- -- -- -- -- --
Sentry Switch
-- -- -- -- -- -- -- --
The numbers across the top of the screen are the relay
positions at that board address.
For a single GR 2432 card in 8 zone mode this is easy to
think with. However it becomes a bit more diff icult with a GR
2448. Relay number 29 would be at the 4th board address
relay number 5. See the Chart to the right to work out the
relay number.
Tab to the correct relay and use the Scroll Buttons, UP or
DOWN, to change the status of the relevant relay.
3
BOARD 1
BOARD SET TING
Actual
Relay
Number
12 45678
RLY
1
RLY
2
RLY
3
RLY
4
RLY
5
RLY
6
RLY
7
RLY
8
RLY
9
RLY
10
RLY
11
RLY
12
RLY
13
RLY
14
RLY
15
RLY
16
RLY
17
RLY
18
RLY
19
RLY
20
RLY
21
RLY
22
RLY
23
RLY
24
RLY
41
RLY
42
RLY
43
RLY
44
RLY
45
RLY
46
RLY
47
RLY
48
BOARD 2
BOARD 3
BOARD 4
BOARD 5
BOARD 6
A "Y" Under Normally Closed means that the logic for this
relay has been reversed to correctly drive a normally closed
relay.
The NO BLINK line is for HID Loads.
HID Loads (High Intensity Discharge Lamps) should not be
given a "Blink Warning." An HID load will go into the re-
strike mode and may take 15 minutes to get back up to full
brightness after even a 1/2 cycle loss of power.
Page 39
To Next Page
Loading...