8230E Optical Power Meter Operation Manual
1.11 Cleaning
1-11
1.11 Cleaning
1.11.1 Cleaning the 8230E
Use a soft or damp cloth to clean the 8230E.
CAUTION: Do not allow water inside the instrument.
Do not use organic solvents solutions such as benzene, toluene, xylene, acetone, or thinner for
cleaning because they deform the plastic.
1.11.2 Cleaning the Incident Surface of the Sensor
If the incident surface is contaminated, clean the surface lightly with a clean cotton swab dipped in dehy-
drated ethanol.
CAUTION: Be careful not to wipe the incident surface of the 82313 or 82323 too heavily because the surface
coating may be damaged.
1.12 How to Store and Transport the Instrument
1.12.1 Storage
If the sensor will not be used for a long period of time, to prevent sensor damage, such as mechanical and
chemical, do not store in the following environments:
• Places where the instrument is exposed to direct sunlight or strong ultraviolet.
• Places where corrosive gas is generated.
• Dusty places
• Places with vibrations
• High temperature and high humidity places
Although this instrument must be in a temperature from -20C to +70C and in a humidity of 80% or
less, if stored for a long time, this instrument should be stored at room temperature and in a low hu-
midity environment.
1.12.2 Transportation
Use the original packing materials or equivalent materials when transporting and avoid excessive vibra-
tions and impacts.
To Next Page
Loading...
Need help?
General
