User’s Manual
6
CAUTION: When performing a Factory Reset, you will lose any settings you
have saved.
Cut off the power from the camera. → Press the factory reset switch. → Turn on the power
while holding the reset switch → Release the switch in about 5 seconds after the Power LED
blinks. → The camera resets to factory defaults and restarts after completing the factory reset.
You can perform a factory reset while the camera is turned on by pressing the factory reset
switch and releasing the reset switch. A factory reset also can be performed remotely by
running the INIT program. The camera restarts after completing the factory reset. Refer
to the INIT User’s Manual for details on remote factory resetting.
2.3 Mounting
Mounting Template
1. Screw the body to the wall or ceiling by using the screws provided with the camera. Use
the mounting template provided with the camera.
2. Connect the external devices, network and power adapter.
3. Adjust the angle of the lens for the proper view angle. Refer to the View Angle section
below for details. Make sure that the sensor in the middle of IR LEDs is not blocked by
the dome cover; otherwise, the IR LEDs might malfunction.
4. Screw the dome cover to the body by using the screws provided with the camera.
5. Apply power.
NOTE: You might need to reinforce the wall or ceiling. If the wall or ceiling is not strong e
nough to support the camera, the camera may fall.
To Next Page
Loading...
Need help?
General
