To Next Page

To Previous Page

Network Camera

Chapter 1 — Introduction

1.1 In This Manual

This manual is intended for users of the network camera and includes instructions for using

and managing the camera on the network.

1.2 Features

This network camera compresses live video and transmits the video over Ethernet connections.

The camera can be accessed, configured and managed by using the INIT (Integrated Network

Installation Tool) program. It has a built-in web server, WebGuard, allowing you to monitor

live video and search recorded video remotely using a web browser. The remote programs

provided with the camera also allow remote management, monitoring, searching and

recording. This camera offers the following features:

 Dual stream for both live monitoring and recording or for live monitoring only

 H.264 and M-JPEG compression algorithm

 Four levels of video compression and various video compression resolutions

 Two-way audio communication

 Pre- and post-event buffering and video stream buffering to enhance reliability of network

recording

 Remote monitoring and searching via web browser or remote software

 Automatic HTML code generation for webcasting on a user’s website

 Up to 10 simultaneous connections to the camera for remote monitoring

 Enhanced security using IP address filtering, HTTPS, SSL and IEEE 802.1X functions

and password protected multiple user levels

 Network bandwidth limit and MAT functions to use network bandwidth efficiently

 Convenient network connection using the UPnP (Universal Plug and Play) function and

built-in mDNS (Multicast DNS) protocol

 Support of the ONVIF protocol (Core specification version 1.02)

 Convenient firmware upgrades via the network connection

 Firmware duplication and autorecovery functions to enhance system stability

 Management of multiple cameras via Ethernet connections

 Event detection functions: motion, audio, video blind

 SD memory recording to provide redundancy in case of network disconnection

 Power sources: 12 VDC, PoE (Power over Ethernet)

NOTES:

 In this manual, a “remote system” refers to a PC that the remote program (RASplus,

iNEX Basic or WebGuard) is running.

 Remote monitoring and recording through dual stream are available by using the RASplus

and iNEX Basic programs provided with the camera.

ADT Network Camera User Manual

Questions and Answers: