Network Camera
11
Date/Time: Change the system date/time, date/time format and time zone. Turn daylight-
saving time on or off by checking the box. Clicking the Apply button applies the changes
immediately.
Time Sync
− Automatic Sync: Check the box to automatically synchronize the time with a time server.
Enter the IP address or the domain name of the time server and set the time interval for
synchronization. If the time server uses the DVRNS function, selecting the Use DVRNS box
allows you to enter the name instead of the IP address or the domain name of the time server.
− Run as Server: Check the box to run the camera as a time server.
NOTE: If you want to use a domain name instead of the IP address of the time server,
the DNS server must be set up properly when setting Network – IP Address setup. If
you want to use a name instead of the IP address or the domain name of the time server,
the DVRNS function must be set up properly when setting the Network – DVRNS setup.
User/Group
User/Group: Click the buttons to change the settings for a group or a user allowed
controlling the camera remotely.
− Add Group: Click to add a group. Enter the group name and set authority levels for the
group to control the camera remotely.
− Add User: Click to add a user. Enter the user name and select the group that the user will
belong to. Enter the password to be assigned to the user.
− Edit: Select a group and click the button to change authority levels assigned to the group,
or select a user and click the button to change the user’s password.
− Delete: Select a group or user and click the button to delete the group or user.
To Next Page
Loading...
Need help?
General
