ADT Network Camera User Manual

User’s Manual
14
DVRNS
Check the DVR Name Service box to use the DVRNS function.
 DVRNS Server: Enter the IP address or domain name of the DVRNS server.
 Port: Set up the port number of the DVRNS server.
 Use NAT: Check the box when the camera uses a NAT (Network Address Translation)
device for network connection.
 Camera Name: Enter the camera name to be registered on the DVRNS server. Check
whether or not the name is available by clicking the Check button.
 Help Desk: Choosing the OK button registers the camera on the DVRNS server. Proper
DVRNS settings will display the help desk information of the DVRNS server.
NOTES:
 The DVRNS (DVR Name Service) function allows the camera to use dynamic IP
addresses for remote connection. When using this function, you can access the camera
remotely by using the camera name instead of its IP address. For the DVRNS function
to work properly, the camera should be registered on the DVRNS server, and the DVRNS
server settings in the INIT program for the camera should match the settings registered
on the DVRNS server. Any changes on the DVRNS server might cause improper
operation.
 When LAN settings are changed, set up the DVRNS settings after saving your LAN
changes by clicking the OK button.
 You will need to get the IP address or domain name of the DVRNS server from your
network administrator. You can use the domain name instead of IP address if you set
up the DNS server during the IP Address setup.

ADT Network Camera Specifications

General

Brand	ADT
Model	Network Camera
Category	Security Camera
Language	English