ADT Network Camera User Manual

Network Camera
21
 Noise Filter: Set the degree of the noise filtration. This adjustment can be used to decrease
noise in low light conditions. The higher the value is set, the less the noise there is.
However, too high of a setting might cause overall image blurring.
 Anti-Flicker: Set to the same frequency as the lighting when the AC power is used for the
lighting such as a fluorescent lights. This reduces video flicker caused by the frequency
differences (60 Hz for NTSC, 50 Hz for PAL).
 White Balance
− Auto: Select to adjust the white balance automatically. The system identifies the light source
of where the camera is installed and sets up the proper white balance for the conditions.
− Manual: Select to adjust the white balance manually. Adjust the Red and Blue gain. The
higher the value, the stronger the color is.
NOTE: Selecting Auto for some functions sets up the functions automatically based on
the conditions.
Streaming
 Primary, Secondary: The camera supports dual stream video. The secondary stream
setting is dependent on the primary stream setting. In the dual stream mode, some event
actions (FTP upload and image attachment to Emails) are disabled.
 Stream: Select the stream usage.
− Live/Recording: Allows simultaneous live monitoring and recording. This is supported
only in one of the streams.
− Live: Allows live monitoring only.
 Compression: Set up the compression of images for streaming. The primary stream
supports only H.264 compression.

ADT Network Camera Specifications

General

Brand	ADT
Model	Network Camera
Category	Security Camera
Language	English