User’s Manual
18
Security
IP Filtering: Check the box to use the IP filtering function. You can allow or block
connections to the camera by designating IP addresses.
− Add: Click the button to add IP addresses to the Allow List or Deny List to allow or block
connection to the camera. Selecting the Host option allows you to add one IP address at a
time. Selecting the Group option allows you to add continuous IP address numbers in one
action by designating a range of IP addresses to add.
− Remove, Remove All: Click the button to remove the selected IP address or all IP addresses
from Allow List or Deny List.
SSL: Check the box to use the SSL function. You can enhance the security of outgoing
data from the camera by using the SSL (Secure Sockets Layer) protocol. When using
the SSL function, the camera cannot be connected with a program or a system that does
not support the SSL function. Remote Setup closes after saving the changes.
NOTES:
If you want to use the time synchronization, DVRNS and Email sending functions, the
connection of the IP addresses of the time server, DVRNS server and the SMTP server
must be allowed when you set up the IP filtering function. Any connection to the camera
from the IP address in Deny List will NOT be allowed.
Using the SSL function might cause congestion in the system receiving data from the
camera depending on the security level.
This product includes software developed by the OpenSSL Project for use in the
OpenSSL Toolkit (http://www.openssl.org/)
To Next Page
Loading...
Need help?
General
