ADT Network Camera User Manual

User’s Manual
30
 Total Capacity: Displays the total capacity of the SD memory card when an SD memory
card is inserted properly.
 Format SD Card: Click the button to format the inserted SD memory card. Formatting
the SD memory card deletes all data saved on the SD memory card. Only users belonging
to the Administrator group can format the SD memory card.
 Exclusive Recording Stream: Check the box to block remote connection to the Live/
Recording stream. It causes the camera to record video only on the SD memory card
while disabling remote recording. It allows you to record video with higher quality when
an event is detected (not supported when compression of Live/Recording stream is set
to JPEG).
 Quality: Select the recording quality for images. This is not supported when the Exclusive
Recording Stream option is disabled or when the compression of Live/Recording stream
is set to JPEG.
− Normal: Select the quality for recording when in the time-lapse recording mode or pre-event
recording when in the event recording mode.
− Event: Select the quality for post-event recording when in the event recording mode.
 Duration: Select the time span to record video when in the event recording mode.
− Post-Event: Select the time span to record video after an event is detected.
− Pre-Event: Select the time span to record video before an event is detected. The camera
can record a maximum of 20 MB of video. If the resolution, quality and frame rate for
recording are set too high and recording capacity during the duration exceeds 20 MB, not
all video during the duration will be recorded.
 Audio Record: Select whether or not to record audio.
 Schedule: Set up the recording schedule. It
records video with the values set for Live/
Recording stream during Video – Streaming setup. If the Exclusive Recording Stream
option (above) is enabled, the quality value set during Quality setup (above) is applied.
− Always – Event: Records video in the event recording mode. Video is recorded only when
an event is detected
.
− Always – Time-Lapse: Records video in the time-lapse recording mode. Video is recorded
continuously regardless of event detection.
− Always – Time-Lapse/Event: Records video in the time-lapse recording mode while no
event is detected and changes to the event recording mode when an event is detected.
− Date/Time: Records video in the preset recording mode for each date and time setting.
Select On or Off and then select the recording mode. Set up or release the recording mode
by clicking or dragging the date and time area in the table. Selecting On or Off and clicking
the Select All/Clear All button sets up or releases the recording mode for all dates and time.
NOTES:
 Searching and playing back video recorded on the SD memory card is supported by
using a remote program. Refer to the User’s Manual for the remote program for details.
 Uncheck the Record box before you remove the SD memory card. Removing the SD
memory card while images are being recorded on the SD memory card might cause
damage the system and saved data.
CAUTION: Searching and playing back video recorded on the SD memory card
might not be very smooth when using a remote program while also recording
video on the SD memory card.

ADT Network Camera Specifications

General

Brand	ADT
Model	Network Camera
Category	Security Camera
Language	English