Adtech CNC9650 User Manual

ADTECH9 Series CNC Maintenance Manual
- 153 -
Y axis pitch compensation end position
Z axis pitch compensation end position
A axes pitch compensation end position
B axis pitch compensation end position
C axis pitch compensation end position
Range : -9999.999 ~ 9999.999
Unit : mm
Authority : Super Admin
Default : 0
Effective time : Instant
Note : Set the compensation of the end position, corresponding to the machine
coordinate position. This value depends on the measured travel and has
both positive and negative values. To measure pitch compensation from
mechanical zero position to mechanical -110mm position, the value is set
to -110mm; to measure from mechanical zero position to mechanical 110,
the value is set to 110mm. After setting the starting position and end
position, the mechanical coordinate position of the system trajectory only
compensates the pitch error in this region.
045 X servo device address
Y servo device address
Z servo device address
A servo device address
B servo device address
C servo device address
Range : 0 ~ 255
Unit :
Authority : Super Admin
Default : 0
Effective time : Instant
Note : It is used to set the address when it accesses servo slave as a Modbus
master, i.e. the ID number.

Adtech CNC9650 Specifications

General

Brand	Adtech
Model	CNC9650
Category	Control Systems
Language	English