Advanced Instruments OsmoPRO Multi-Sample - Page 73

OsmoPRO® Multi-Sample Micro-Osmometer User’s Guide
73
9.2.5 General usage error messages
Contained in the table below is a list of error messages the user could encounter while
operating the instrument.
Error Message
Suggested Actions
Printer Out of Paper
Replacing the printer paper, then clear error
Printer Door Open
Close the printer door and clear error
Calibration Required
Instrument settings changed, such as probe resistances
or motor alignment; instrument needs new calibration
Perform a successful calibration test, then clear error
Turntable proximity sensor:
too much ambient light
Tube proximity sensor:
too much ambient light
Move the instrument away from excessive ambient light
and clear error
Table 9.1: General Usage Error Messages