AED Saver One - Inserting and Removing the Batteries

AUTOMATIC
18
5.1.4 Inserting and removing the batteries
To be able to operate the Saver One the insertion of a battery is required. Below are detailed instructions for correctly
installing the batteries (rechargeable or non-rechargeable) in the Saver One.
 Place the device on the side as shown in the figure (6)
 Hold the device firmly with your left hand as shown in figure (6)
 Insert the battery as shown in figure (6) following the direction of the arrow and matching it perfectly with the
point highlighted by the circle
 Push the battery as shown in figure (7) following the direction of the arrow, until you hear a click that confirms the
correct insertion
Follow the instructions below to remove the battery:
 Position the device as shown in figure (8)
 Hold the device firmly with your left hand as shown in figure (8)
 Using two fingers of the right hand press on the battery hook highlighted by the circle in figure (8)
 At the same time pull the battery in the direction indicated by the arrow shown in figure (9)
Image 6
Image 7
Image 8
Image 9