AUTOMATIC
36
10.3 Cleaning
The structure of the Saver One defibrillator, including the connection port of the defibrillation electrodes, can be
sanitized using a soft cloth dampened with one of the cleaning solutions listed below:
a) Isopropyl alcohol (70% solution)
b) Soap water
c) Bleach (30 ml per litre of water)
d) Detergents containing ammonia
e) Detergents containing glutaraldehyde
f) Oxygenated water
Do not immerse the Saver One in any liquid.
Do not use abrasive materials or detergents, strong solvents such as acetone or acetone-based detergents, and enzymatic
detergents.
Do not sterilize the Saver One or its accessories.
10.4 Preservation
The Saver One must be stored in a place where the environmental and safety conditions indicated in the table below
are observed according to the temperature and humidity indicated in the chapter 12.2. If installed it is advisable to keep
the device with the battery always inserted to allow it to carry out periodic self-diagnostic tests. For easy retrieval of the
device in case of emergency, place it in easily accessible place and faced in a way that the control LEDs are clearly
visible.
Do not use, install or store the
Saver One in conditions of
temperature or humidity that
exceed the ranges indicated in
this user manual.
Do not install or store the Saver
One in areas directly exposed
to sunlight.
Do not install or store the
Saver One in areas subjected
to sudden changes in
temperature or humidity.
Do not install or store the Saver
One near heat sources.
Do not use, install or store the
Saver One in places subjected
to strong vibrations.
Do not use, install or store the
Saver One in environments
with high concentrations of
flammable gases or
anaesthetics.
Do not install or store the
Saver One in areas with a
high concentration of dust.
The Saver One must be opened
for maintenance only by A.M.I.
Italia S.r.l or by personnel
authorized by the same.
To Next Page
Loading...