AED Saver One - Technical specifications

AUTOMATIC
38
11 Technical specifications
The technical specifications of the Saver One defibrillator, its parts and accessories are shown below.
11.1 Physical characteristics
Category
Nominal specifications
Dimensions
26,5 x 21,5 x 7,5 cm
Weight
With battery Li-SOCl
2
(SAV-C0903):
1,95 Kg including Adult Pads
With battery Li-ion (SAV-C0011):
2,00 Kg including Adult Pads
11.2 Environmental requirements
Category
Nominal specifications
Temperature
Operational and
standby:
0 a 55°C (32 a 131°F)
Storage and transport:
-40 a 70°C (-40 a 158°F)
Relative humidity
Operational and
standby:
10% a 95% (without condensation)
Storage and transport:
without humidity control (from -40°C to +5°C)
up to 90% (from + 5 ° C to +35°C)
with water vapour up to 50 hPa (from>35°C to +70°C)
Atmospheric pressure
Operating conditions:
620 hPa at 1060 hPa
(altitude calculated min -382 mt and max 3955 mt)
Operating functional
conditions
Normal use:
Keep the AED device within the operating and standby ranges (not
the storage and transport ranges) so that the device is ready for use.
When starting from the inoperative conditions, let the device
stabilize at the operating conditions for at least 2 hours, before the
normal use.
Tolerance to impacts and
falls
Complies with IEC/EN 60601-1clause 21 (mechanical forces)
Sealing system
Complies with IEC/EN 60529 class IP54 standards; anti-spray, dustproof (with battery
installed)
ESD (electrostatic shock)
Complies with IEC/EN 61000-4-2:2002 (3), Security level 4
EMC emissions / immunity
See chapter 12
11.3 Reference regulations
Regulations and Directives
DIRECTIVE 2007/47/CE
IEC/EN 60601-1
IEC/EN 60601-1-2
IEC/EN 60601-1-4
IEC/EN 60601-1-6
IEC/EN 60601-1-8
IEC/EN 60601-1-11
IEC/EN 60601-1-12
IEC/EN 60601-2-4
IEC/EN 60086-4
IEC/EN 60529