52
• Pressing and releasing the M button momentarily and repeatedly (< 2
seconds each time) will step back through the Set Points one at a time.
• Pressing and releasing the A button momentarily (< 2 seconds) will accept
the Set Point and access Set DD 2.
• Depressing the M button for 2 seconds, or if no button is pressed during a
period of 2 minutes, operation will revert to the SURF MAIN screen.
SET DD 2 ALARM, information includes (Fig. 49) -
> Graphic DD2 (meaning Descending Depth 2)
> Depth Alarm value, flashing if ON is selected, with MAX and FT (or M) icons
> Set Point ON or OFF, flashing
• Pressing/releasing the S button momentarily (< 2 seconds) will toggle the Set
Point between ON and OFF.
• Pressing/releasing the A button momentarily (< 2 seconds) will accept the
ON/OFF setting.
> If OFF is accepted, Set DD 3 will be bypassed and the
display will revert to the SURF MAIN screen.
> If ON is accepted, the Depth value displayed will flash.
• Pressing and releasing the S button momentarily (< 2
seconds each time) while the Depth value is flashing will
step upward through the Set Points from a minimum of 40
to 330 FT (11 to 100 M) in increments of 10 FT (1 M).
• Depressing and holding the S button will scroll upward
through the Set Points at a rate of 8 Set Points per second
until released.
Fig. 49 - SET DD 2
ALARM
To Next Page
Loading...
