Aeris F10 - Page 53

53
• Pressing and releasing the M button momentarily (< 2 seconds each time) will
step back through the Set Points one at a time.
• Pressing and releasing the A button momentarily (< 2 seconds) will accept the
Set Point and access Set DD 3.
• Depressing the M button for 2 seconds, or if no button is pressed during a
period of 2 minutes, operation will revert to the SURF MAIN screen.
SET DD 3 ALARM, information includes (Fig. 50) -
> Graphic DD3 (meaning Descending Depth 3)
> Depth Alarm value, flashing if ON is selected, with MAX and FT (or M) icons
> Set Point ON or OFF, flashing
• Pressing/releasing the S button momentarily (< 2 seconds) will toggle the Set
Point between ON and OFF.
• Pressing/releasing the A button momentarily (< 2 seconds) will accept the
ON/OFF setting.
> If OFF is accepted, operation will revert to the SURF MAIN screen.
> If ON is accepted, the Depth value displayed will flash.
• Depressing the S button will scroll upward through the Set
Points at a rate of 8 per second from a minimum of 50 to
330 FT (12 to 100 M) in increments of 10 FT (1 M).
• Pressing and releasing the S button momentarily (< 2
seconds each time) will step upward through the Set
Points one at a time.
Fig. 50 - SET DD 3
ALARM