AERMEC WRC1 User Manual

76
EN
Code
Type
signal
Description
Indoor unit Air quality alarm
Indoor unit Incompatibility between indoor and outdoor units
Indoor unit Indoor unit control electric card error
Indoor unit Room air sensor error
Indoor unit Error on temperature probe on coil inlet
Indoor unit Error on temperature probe on coil outlet
Indoor unit Humidity probe error
Indoor unit Water temperature probe error
Indoor unit Jumper cap position error
Indoor unit Indoor unit addressing error
Indoor unit Connection error between wired panel and Indoor unit control card
Indoor unit Dip switch setting error for selecting size
Indoor unit Room air probe error
Indoor unit Carbon dioxide probe error
Indoor unit Indicates that Debug mode is active
Status codes Unit on hold because of debug mode
Status codes Compressor operating parameter control procedure underway
Status codes Insufficient refrigerant gas quantity warning (replenishment required)
Status codes Defrosting cycle currently underway
Status codes Unit in test mode
Status codes Pump down mode currently underway
Status codes Indoor unit air filter cleaning warning
Status codes System emergency stop (from remote system)
Status codes System emergency stop
Status codes Protected operation
Debug codes Jumper cap setting error on outdoor unit (capacity selector)
Debug codes Protection on system power supply phase sequence

AERMEC WRC1 Specifications

General

Brand	AERMEC
Model	WRC1
Category	Control Panel
Language	English