Need help?Do you have a question about the AERMEC WRC40 and is the answer not in the manual?
General| Category | Control Panel |
|---|---|
| Mounting | Wall-mounted |
| Power Consumption | 5 VA |
| Operating Temperature | 0°C to +50°C |
| Storage Temperature | -20°C to +60°C |
| Relative Humidity | 10% to 90% non-condensing |
| Display | LCD |
| Communication | RS485 Modbus RTU |
| Outputs | Relay outputs |
Essential safety guidelines for handling electrical devices and ensuring correct installation.
Precautions for users regarding device operation, maintenance, and handling.
Critical safety instructions and compliance requirements for installation personnel.
Instructions on how to power the indoor unit on or off using the wired panel.
Guide to choosing between Auto, Cooling, Dehumidification, Ventilation Only, and Heating modes.
How to adjust the fan speed for optimal airflow and comfort.
How to control the left and right movement of the air discharge fins.
Information regarding the availability of the fresh air function.
Explanation of the Sleep mode for enhanced night-time comfort and energy saving.
Setting the air delivery fin to a fixed angle instead of swing.
Defines the set-point for dehumidification mode as 12 °C.
How to switch the temperature display between Celsius and Fahrenheit.
Allows the unit to continue working towards a set-point after switch-off.
Instructions for activating, deactivating, and resetting the Wi-Fi module.
How to set a single timed switch-on or switch-off operation.
How to set a countdown for the unit to switch off automatically.
How to view various operational parameters of the unit.
Access to advanced debug functions intended for assistance personnel.
Setting the serial address for the indoor unit when using a centralizer.
Adjusting measured room temperature to compensate for probe accuracy.
Modifying the static pressure for fans in specific duct type indoor units.
Enabling or disabling the protection function against refrigerant leaks.
Enabling or disabling the display of the anti-freeze alarm (error code E2).
Selecting the type of ventilation control for the compressor heater.
How to activate or deactivate the energy saving mode.
To Next Page
