28
SETTING THE VENTILATION MODE AFTER
THE SETPOINT HAS BEEN REACHED
This function is used to choose the type of
ventilation control to be applied once the operating
set-point has been reached. To set this function,
select the waste heat blow mode label using
the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
key, then use
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
to choose the
required value:
1 (logic 1) In cooling mode, the indoor unit keeps
the ventilation active even when the operating set-
point has been reached whereas, in heating mode,
DUCT TYPE and FLOOR CEILING units keep the
ventilation active for 60 seconds without altering
the fan speed, and CASSETTE units set the minimum
speed;
2 (logic 2) Once the operating set-point has been
reached (in both heating and cooling), ventilation is
suspended after 10 seconds.
OFF function not active.
SETTING THE CONTROL MODE FOR THE
COMPRESSOR HEATER
This function is used to choose the type of
ventilation control to be applied once the operating
set-point has been reached. To set this function,
select the waste heat blow mode label using
the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
key, then use
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
to choose the
required value:
1 (logic 1) In cooling mode, the indoor unit keeps
the ventilation active even when the operating set-
point has been reached whereas, in heating mode,
DUCT TYPE and FLOOR CEILING units keep the
ventilation active for 60 seconds without altering
the fan speed, and CASSETTE units set the minimum
speed.
2 (logic 2) Once the operating set-point has been
reached, in both heating and cooling, ventilation is
suspended after 10 seconds.
OFF function not active.
SETTING THE ENERGY SAVING FUNCTION
This function activates or deactivates energy saving
mode. To set this function, select the low power
mode label (using the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
key) then use
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
to choose the required value
1 function active;
2 function not active.
WARNING:
In order to use the ECD accessory, it MUST be
enabled via this parameter.
ENABLING OR DISABLING THE ECD
ACCESSORY
This function is used to enable the ECD accessory (if
fitted). To set this function, select the gate control
label (using the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
key) then use
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
to
choose the required value:
On accessory fitted.
Off accessory not fitted.
FUNCTION NOT AVAILABLE
Certain functions visible in this menu are not
currently available, so their setting produces no
change in the system. They are:
Human sensitive function.
The angle of return air.
To Next Page
Loading...
