310 Agilent 1260 Infinity DAD and MWD User Manual
Index
DRC
run recovery 81
drift (ASTM) and noise 24, 27, 30, 33
DSP not running 141
E
electrical connections
descriptions of 245
EMF
early maintenance feedback 259
entrance slit 12
environment 22, 22, 22
error messages
compensation sensor open 129
compensation sensor short 130
cover violation 133
diode current leakage 135
DSP not running 141
fan failed 130
heater failed 140
heater power at limit 140
holmium oxide test failed 138
ignition without cover 133, 133
illegal temperature value from sensor
at air inlet 139
illegal value from sensor on main
board 138
leak sensor open 129
leak sensor short 128
leak 131
lost CAN partner 128
no run data available in device 141
remote timeout 127
shutdown 127
timeout 126
uv heater current 137
uv ignition failed 136
uv lamp current 135
uv lamp voltage 136
visible lamp current 134
visible lamp voltage 134
wavelength calibration failed 137
wavelength recalibration lost 139
F
fan failed 130
features
safety and maintenance 35, 26,
29, 32
filter test 145
firmware
description 242
main system 242
resident system 242
update tool 243
updates 243, 203, 203
upgade/downgrade 203
upgrade/downgrade 203
flow cell
correction factors 104
installation 51
solvent information 299
specifications 34, 25, 28, 31
support windows 12
test 156
frequency range 23
G
general error messages 126
GLP features 26, 29, 32, 35
grating 12, 13
H
holmium oxide
declaration of conformity 301
filter 12
test 151
humidity 23
I
information
on uv-radiation 298
initialization mode selection 265
installation
bench space 22
delivery checklist 39
environment 22, 22, 22
flow connections 51
of flow cell and capillaries 51
of the detector 48
site requirements 19
unpacking 38
instrument layout 258
intensity test 148
interfaces 247
internet 308
introduction
optical unit parts 12
L
lamps 12
LAN
automatic configuration with
Bootp 273
Bootp & Store 266
Bootp 265
cable 239
configuration switch 264
configuration 261
initialization mode selection 265
link configuration selection 272
manual configuration with
telnet 285
manual configuration 284
storing the settings
permanently 283
TCP/IP parameter configuration 263
using default 267
using stored 267
To Next Page
Loading...
