EasyManuals Logo

Agilent Technologies 1260 Infinity II Refractive Index Detector User Manual

Agilent Technologies 1260 Infinity II Refractive Index Detector
217 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #189 background imageLoading...
Page #189 background image
Agilent InfinityLab LC Series RID User Manual 189
13 LAN Configuration
Dynamic Host Configuration Protocol (DHCP)
Setup (DHCP)
1
Note the MAC address of the LAN interface (provided with G1369C LAN
Interface Card or Main Board). This MAC address is on a label on the card or
at the rear of the main board, e.g. 0030d3177321.
On the Local Controller the MAC address can be found under
Details
in the
LAN section.
Figure 37 LAN Setting on Instant Pilot
The DHCP functionality is available on all Agilent HPLC modules with on-board LAN Interface or LAN
Interface Card G1369C, and “B”-firmware (B.06.40 or above) or modules with "D"-firmware. All mod-
ules should use latest firmware from the same set.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies 1260 Infinity II Refractive Index Detector and is the answer not in the manual?

Agilent Technologies 1260 Infinity II Refractive Index Detector Specifications

General IconGeneral
BrandAgilent Technologies
Model1260 Infinity II Refractive Index Detector
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals