Agilent Technologies 1260 Infinity II Refractive Index Detector User Manual

Agilent InfinityLab LC Series RID User Manual 49
3Using the Module
Set up the Detector with Agilent Open Lab ChemStation
Set up the Detector with Agilent Open Lab
ChemStation
The setup of the detector is shown with the Agilent OpenLab ChemStation
C.01.07 and LC and CE Drivers A.02.13.
Figure 13 ChemStation Method and Run Control (just detector is shown)
After successful load of the OpenLab ChemStation, you should see the module
as an active item in the graphical user interface (GUI).
NOTE
This section describes the detector settings only. For information on the Agilent
OpenLab ChemStation or other 1200 Infinity modules refer to the corresponding
documentation.

Agilent Technologies 1260 Infinity II Refractive Index Detector Specifications

General

Brand	Agilent Technologies
Model	1260 Infinity II Refractive Index Detector
Category	Laboratory Equipment
Language	English