Agilent InfinityLab LC Series RID User Manual 51
3Using the Module
The Detector User Interface
EMF Status shows Run / Ready / Error state and “Not Ready
text” or “Error text”
• Offline (gray)
• Ok. No Maintenance required (green)
• EMF warning. Maintenance might be required (yellow)
• EMF warning. Maintenance required (red)
Important: The EMF settings can be accessed via Agilent Lab
Advisor. The limit(s) can be changed. Based on the limit, the
User Interface displays the above status.
Module Status shows Run / Ready / Error state and “Not
Ready text” or “Error text”
• Error (red)
• Not ready (yellow)
• Ready (green)
• Pre run, Post run (purple)
• Run (blue)
• Idle (green)
• Offline (dark gray)
• Standby (light gray)
A right-click into the Active Area will open a menu to
• Show the Control Interface (special module settings)
• Show the Method interface (similar as via menu Instru-
ment> Setup Instrument Method)
• Set Error Method
• Identify Module (Status LED will blink)
• Perform a Balance
• Switch the Heater on/off (same as click on button Make
Device Ready/Turn device off (standby))
• Open/close Purge Valve
• Recycle Valve on/off
To Next Page
Loading...
Need help?
General
