69
Chapter 2 Front-Panel Menu Operation
To Configure the Remote Interface
4
2
3
Press
Modify Settings
.
To access most items on this screen, you must use the first softkey to
switch from DHCP to Manual. With DHCP on, an IP address will
automatically be set by DHCP (Dynamic Host Configuration Protocol)
when you connect the instrument to the network, provided the DHCP
server is found and is able to do so. DHCP also automatically deals with
the subnet mask and gateway address, if required. This is typically the
easiest way to establish LAN communication for your instrument. All you
need to do is leave DHCP on. Contact your LAN administrator for more
information.
To Next Page
Loading...
