Breadboard Module 13
34980A User’s Guide 319
Installing Custom Circuitry on the 34959A Breadboard Module
Connection to the Ribbon Cable Headers
The two supplied headers P101 and P102 have ejecting latches and
polarization notches. Although individual crimp terminals can be used to
connect to the header pins, the most secure connection will be achieved by
using keyed ribbon cable connectors. The selection of ribbon connectors is
left to the user. However, if you desire to hard- solder connections to your
custom PC board, the following diagram and connector part numbers are
offered as a suggestion:
Connection from Headers P101 and P102 to a Custom PC Board
Suggested Part Numbers for Ribbon Cable Connections Shown above
The suggested suppliers for these cables and connectors are:
Vendor: 3M Corporation
Vendor Address: 6801 River Place Boulevard, Austin, TX 78726 U.S.A.
Vendor: AMP
Vendor Address: Harrisburg, PA 17105 U.S.A.
Part Description AMP Part Number 3M Part Number
for connection to 26-pin header
A 26-pin wire-mount socket 746288-6 3399-xxxx
B 26-pin strain relief 499252-3 3448-3026
C 26-conductor ribbon cable 971111-3
D PC-board mount 2-216093-6
for connection to 40-pin header
A 40-pin wire-mount socket 746288-9 3417-xxxx
B 40-pin strain relief 499252-1 3448-3040
C 40-conductor ribbon cable 971111-5
D PC-board mount 4-216093-0
To Next Page
Loading...
Need help?
General
