2-15
Using the 86100C
Quick Measure
Quick Measure
Press Quick Measure and the Infiniium DCA automatically performs four mea-
surements on a displayed signal. Although there is a default set of measure-
ments for each instrument mode, except Jitter mode, you can select the
measurements to fit your needs. For example, in Oscilloscope mode the
default measurements are: rise time, fall time, period, and V amplitude. In
Eye/Mask mode you can also configure Quick Measure to perform a mask test.
In Jitter mode, Quick Measure displays graphs and can not be configured.
To configure Quick Measure
• Click Measure > Quick Measure Config.
Figure 2-10. The Quick Measure Button
To Next Page
Loading...
