2-24
Using the 86100C
If the Infiniium DCA has a Problem
you block these features, you can always reconfigure the firewall at a later
time to allow SICL/LAN control as described in “To configure the firewall” on
page 2-27.
Agilent Connection
Expert’s Automatic
Instrument Detect
Some firewall applications might block an echo request (ping) from the Agi-
lent Connection Expert version 15.0 and above. If a ping is blocked the
"Instrument I/O on this PC" auto-detect function will not find the 86100C DCA
even though it has been added and tested correctly under the Change Proper-
ties dialog box. To resolve this on the Microsoft Windows Firewall, refer to “To
configure the firewall” on page 2-27.
Infiniium DCA Hard
Disk Drive Recovery
The hard drive recovery procedure restores the instrument's hard disk in the
event that files and data have been corrupted. This can happen, for example,
as a result of inadvertent user changes or a computer virus. The procedure for
the 86100C is different from the procedure for the 86100A/B.
On 86100C instruments, the hard disk drive has two partitions: drive C and
drive D. Drive C contains the operating system, the 86100C application, and
any factory installed or user installed applications. Drive C also contains fac-
tory calibration data and application licenses, which are automatically backed
up to drive D. Drive D contains backup files and user files including data files.
If you install an application, such as virus protection, it is recommended, but
not required, that you install it on drive C.
To recover the 86100C Drive-C 2-29
To restore the 86100C Drive-D 2-31
Confirm the Initial
Instrument Settings
Although there are several Windows System settings that can be changed,
avoid changing the settings listed in “Avoid changing these Windows system
settings” on page 2-22, because any changes will interfere with the proper
operation of the Infiniium DCA. Confirm that these setting have not been
changed.
To Next Page
Loading...
Need help?
General
