Chapter 1 1-225
Alphabetical Command Reference
SEG
SEG
Syntax
SEG<IFBW|POWER><num>;
Description
NOTE Currently these commands can be queried by sending the command followed
by the OUTPACTI command, as in the following example to query the upper
limit value:
10 OUTPUT 716;”SEGIFBW;OUTPACTI;”
Future revisions of firmware may support the standard query form (which
currently always returns a zero) for these commands.
Front Panel Equivalents
Command Description Range Query Response
SEGIFBW Sets the IFBW for the active segment of a
list-frequency table in swept list mode.
Choose from 10,
30, 100, 300,
1000, 3000,
3700, 6000
see “Note” below
SEGPOWER Sets the power for the active segment of a
list-frequency table in swept list mode.
output power
range of your
analyzer
1
1. The output power range is dependent upon the model and option configuration of your analyzer. Refer to your
analyzer’s reference guide to determine the output power range of your analyzer.
see “Note below
Command Hardkey Softkey
SEGIFBW
SEGPOWER
Sweep Setup
Sweep Setup
To Next Page
Loading...
Need help?
General
