Chapter 6 6-9
Error Reporting
Error Messages in Numerical Order
Error Messages in Numerical Order
For explanations and suggestions in finding the cause of the error messages, refer to your
analyzer’s reference guide. Some error numbers have been omitted due to obsoleted error
messages.
Error
Number
Error
1 OPTIONAL FUNCTION; NOT INSTALLED
2 INVALID KEY
3 CORRECTION CONSTANTS NOT STORED
4 PHASE LOCK CAL FAILED
5 NO IF FOUND: CHECK R INPUT LEVEL
6 POSSIBLE FALSE LOCK
7 NO PHASE LOCK: CHECK R INPUT LEVEL
8 PHASE LOCK LOST
9 LIST TABLE EMPTY
10 CONTINUOUS SWITCHING NOT ALLOWED
11 SWEEP TIME INCREASED
12 SWEEP TIME TOO FAST
13 AVERAGING INVALID ON NON-RATIO MEASURE
14 FUNCTION NOT VALID
15 NO MARKER DELTA - SPAN NOT SET
16 TRANSFORM, GATE NOT ALLOWED
17 DEMODULATION NOT VALID
21 POWER SUPPLY HOT!
22 POWER SUPPLY SHUT DOWN!
23 PROBE POWER SHUT DOWN!
24 PRINTER: not on, not connect, wrong address
25 PRINT ABORTED
26 PLOTTER: not on, not connect, wrong address
27 PLOT ABORTED
28 PLOTTER NOT READY-PINCH WHEELS UP
30 REQUESTED DATA NOT CURRENTLY AVAILABLE
31 ADDRESSED TO TALK WITH NOTHING TO SAY
To Next Page
Loading...
Need help?
General
