Chapter 6 6-13
Error Reporting
Error Messages in Numerical Order
182 LIST MODE OFF: INVALID WITH LO FREQ
183 BATTERY FAILED. STATE MEMORY CLEARED
184 BATTERY LOW! STORE SAVE REGS TO DISK
185 CANNOT FORMAT DOS DISKS ON THIS DRIVE
186 OK TO ALTER CORRECTION CONSTANTS?
187 SWEEP MODE CHANGED TO CW TIME SWEEP
188 DIRECTORY FULL
189 DISK READ/WRITE ERROR
190 DISK MESSAGE LENGTH ERROR
191 EXT SOURCE NOT READY FOR TRIGGER
192 FILE NOT FOUND
193 ASCII: MISSING 'BEGIN' statement
194 ASCII: MISSING 'CITIFILE' statement
195 ASCII: MISSING 'DATA' statement
196 ASCII: MISSING 'VAR' statement
197 FILE NOT FOUND OR WRONG TYPE
198 NOT ALLOWED DURING POWER METER CAL
199 CANNOT MODIFY FACTORY PRESET
200 ALL REGISTERS HAVE BEEN USED
201 FUNCTION NOT VALID FOR INTERNAL MEMORY
202 FUNCTION NOT AVAILABLE
203 CANNOT READ/WRITE HFS FILE SYSTEM
204 FREQS CANNOT BE CHANGED, TOO MANY POINTS
205 LIMIT TABLE EMPTY
206 ARGUMENT OUT OF RANGE
207 POWER OUT MAY BE UNLEVELED
208 EXT R CHAN MUST BE ON FOR FREQUENCY OFFSET MODE
209 SWEEP MUST BE STEPPED FOR FREQUENCY OFFSET MODE
211 OVERLAP! LIST TYPE CHANGED TO STEPPED
212 ANALOG BUS DISABLED IN 6 kHz IFBW
213 RANGE CAUSED POWER LVL CHANGE IN LIST
Error
Number
Error
To Next Page
Loading...
Need help?
General
