1-100
Making Measurements
Using Test Sequencing
The previous keystrokes will create a displayed list as shown:
Start of Sequence
RECALL PRST STATE
Trans: FWD S21 (B/R)
LOG MAG
CENTER
134 M/u
SPAN
50 M/u
SCALE/DIV
AUTO SCALE
4. To complete the sequence creation, press:
CAUTION When you create a sequence, the analyzer stores it in volatile memory where
it will be lost if you switch off the instrument power (except for sequence #6
which is stored in the analyzer non-volatile memory). However, you may store
sequences to a floppy disk.
Running a Sequence
To run a stored test sequence, press:
and the softkey labeled with desired sequence number.
or, press:
and the softkey labeled with the desired sequence number
Stopping a Sequence
To stop a sequence before it has finished, press .
Editing a Sequence
Deleting Commands
1. To enter the creation/editing mode, press:
2. To select the particular test sequence you wish to modify (sequence 1 in this example),
press:
Seq
Preset
Seq
Local
Seq
To Next Page
Loading...
Need help?
General
