Agilent Technologies 8719ET User Manual

4-21
Printing, Plotting, and Saving Measurement Results
Plotting Multiple Measurements Per Page Using a Pen Plotter
If You Are Plotting to an HPGL Compatible Printer
1. Configure and define the plot, as explained in "Configuring a Plot Function" on page
4-10 and "Defining a Plot Function" on page 4-15.
2. Press to print the data the printer has
received.
NOTE Use test sequencing to automatically plot all four S-parameters.
1. Set all measurement parameters.
2. Perform a full 2-port calibration.
3. Enter the test sequence:
4. Run the test sequence by pressing:
Copy
PLOT
PLOTTER FORM FEED
Seq
NEW SEQ/MODIFY SEQ
SEQUENCE 1 SEQ1
Meas
Refl: FWD S11 (A/R)
Copy
SEL QUAD [ ]
SELECT DISK
LEFT UPPER PLOT
Meas
Trans: FWD S21 (B/R)
Copy
SEL QUAD [ ]
LEFT LOWER PLOT
Meas
Refl: REV S22 (B/R)
Copy
SEL QUAD [ ]
RIGHT UPPER PLOT
Meas
Trans: REV S12 (B/R)
Copy
SEL QUAD [ ]
RIGHT LOWER PLOT
Seq
DONE SEQ MODIFY
Seq
DO SEQUENCE
SEQUENCE 1 SEQ1
1SEQ1

Agilent Technologies 8719ET Specifications

General

Brand	Agilent Technologies
Model	8719ET
Category	Measuring Instruments
Language	English